Consumer Factsheet on: 1,2-DICHLOROETHANE

What is 1,2-DCE and how is it used?

1,2-Dichloroethane (1,2-DCE) is a colorless, oily, organic liquid with a sweet, chloroform-like odor. The greatest use of 1,2-dichloroethane is in making chemicals involved in plastics, rubber and synthetic textile fibers. Other uses include: as a solvent for resins and fats, photography, photocopying, cosmetics, drugs; and as a fumigant for grains and orchards.

The list of trade names given below may help you find out whether you are using this chemical at home or work.

Trade Names and Synonyms:

  • 1,2-Ethylene dichloride
  • Glycol dichloride
  • Freon 150
  • Borer sol
  • Brocide
  • Destruxol borer-sol
  • Dichlor-mulsion
  • Dutch oil
  • Granosan

Why is 1,2-DCE being Regulated?

In 1974, Congress passed the Safe Drinking Water Act. This law requires EPA to determine safe levels of chemicals in drinking water which do or may cause health problems. These non-enforceable levels, based solely on possible health risks and exposure, are called Maximum Contaminant Level Goals.

The MCLG for 1,2-dichloroethane has been set at zero because EPA believes this level of protection would not cause any of the potential health problems described below.

Based on this MCLG, EPA has set an enforceable standard called a Maximum Contaminant Level (MCL). MCLs are set as close to the MCLGs as possible, considering the ability of public water systems to detect and remove contaminants using suitable treatment technologies.

The MCL has been set at 5 parts per billion (ppb) because EPA believes, given present technology and resources, this is the lowest level to which water systems can reasonably be required to remove this contaminant should it occur in drinking water.

These drinking water standards and the regulations for ensuring these standards are met, are called National Primary Drinking Water Regulations. All public water supplies must abide by these regulations.

What are the Health Effects?

Short-term: EPA has found 1,2-dichloroethane to potentially cause the following health effects when people are exposed to it at levels above the MCL for relatively short periods of time: central nervous system disorders, and adverse lung, kidney, liver circulatory and gastrointestinal effects.

Long-term: 1,2-Dichloroethane has the potential to cause the following effects from a lifetime exposure at levels above the MCL: cancer.

How much 1,2-DCE is produced and released to the environment?

Production of 1,2-dichloroethane was 18 billion lbs. in 1993. It is released in waste water, spills, and/or improper disposal primarily from its use as a cleaning solvent, in making other organics, and in pesticides.

From 1987 to 1993, according to the Toxics Release Inventory, releases to water and land totalled over 455,000 lbs. These releases were primarily from facilities which make industrial organic chemicals, alkalis and chlorine. The largest releases occurred in New Jersey and Louisiana.

What happens to 1,2-DCE when it is released to the environment?

While releases to water or soil will evaporate quickly, 1,2-dichloroethane will also leach into groundwater rapidly where it is likely to persist for a very long time. There is little degradation by microbes. 1,2-Dichloroethane is not expected to accumulate in fish.

How will 1,2-DCE be Detected in and Removed from My Drinking Water?

The regulation for 1,2-dichloroethane became effective in 1989. Between 1993 and 1995, EPA required your water supplier to collect water samples every 3 months for one year and analyze them to find out if 1,2-dichloroethane is present above 0.5 ppb. If it is present above this level, the system must continue to monitor this contaminant.

If contaminant levels are found to be consistently above the MCL, your water supplier must take steps to reduce the amount of 1,2-dichloroethane so that it is consistently below that level. The following treatment methods have been approved by EPA for removing 1,2-dichloroethane: Granular activated charcoal in combination with Packed Tower Aeration.

How will I know if 1,2-DCE is in my drinking water?

If the levels of 1,2-dichloroethane exceed the MCL, 5 ppb, the system must notify the public via newspapers, radio, TV and other means. Additional actions, such as providing alternative drinking water supplies, may be required to prevent serious risks to public health.

Drinking Water Standards:

	Mclg:  zero
	Mcl:   5 ppb

	1,2-DCE Releases to Water and Land, 
	1987 to 1993 (in pounds):

	                              Water          Land
	TOTALS (in pounds)            433,056        22,616

	Top Six States*

	NJ                            192,700        231
	LA                            136,508        2,292
	TX                            36,459         7,028
	MO                            6,786          8,730
	NY                            11,330         0
	KY                            10,309         0

	Major Industries

	Industrial organics           211,146        363
	Alkalies, chlorine            120,283        3,254
	Cyclic crudes, intermed.      32,945         119
	Agricultural chemicals        11,918         8,980
	Industrial gases              15,497         0
	Plastics materials, resins    6,908          6,895
	Photographic equip.           11,566         0
	Other Chemicals               8,179          0
	Pharmaceuticals               7,525          521
	Petroleum refining            1,730          1,479

	* Water/Land totals only include facilities with releases 
	greater than a certain amount - usually 1000 to 10,000 lbs.
									 
  

Home | About Us | Water Quality | Education | Information | Site Index