What is Trichloroethylene and how is it used?

Trichloroethylene is a colorless or blue organic liquid with a chloroform-like odor. The greatest use of trichloroethylene is to remove grease from fabricated metal parts and some textiles.

The list of trade names given below may help you find out whether you are using this chemical at home or work.

Trade Names and Synonyms:

• 1,1,2-Trichloroethylene
• Acetylene trichloroethylene
• Algylen
• Anameth
• Benzinol
• Chlorilen
• CirCosolv
• Germalgene
• Lethurin
• Perm-a-chlor
• Petzinol
• Philex
• TRI-Plus M
• Vitran

Why is Trichloroethylene being Regulated?

In 1974, Congress passed the Safe Drinking Water Act. This law requires EPA to determine safe levels of chemicals in drinking water which do or may cause health problems. These non-enforceable levels, based solely on possible health risks and exposure, are called Maximum Contaminant Level Goals.

The MCLG for trichloroethylene has been set at zero because EPA believes this level of protection would not cause any of the potential health problems described below.

Based on this MCLG, EPA has set an enforceable standard called a Maximum Contaminant Level (MCL). MCLs are set as close to the MCLGs as possible, considering the ability of public water systems to detect and remove contaminants using suitable treatment technologies.

The MCL has been set at 5 parts per billion (ppb) because EPA believes, given present technology and resources, this is the lowest level to which water systems can reasonably be required to remove this contaminant should it occur in drinking water.

These drinking water standards and the regulations for ensuring these standards are met, are called National Primary Drinking Water Regulations. All public water supplies must abide by these regulations.

What are the Health Effects?

Short-term: EPA has found trichloroethylene to potentially cause the following health effects when people are exposed to it at levels above the MCL for relatively short periods of time: vomiting and abdominal pain.

Long-term: Trichloroethylene has the potential to cause the following effects from a lifetime exposure at levels above the MCL: liver damage; cancer.

How much Trichloroethylene is produced and released to the environment?

Production of trichloroethylene has increased from just over 260,000 lbs. in 1981 to 320 million lbs. in 1991. Major environmental releases of trichloroethylene are due to air emissions from metal degreasing plants. Wastewater from metal finishing, paint and ink formulation, electrical/electronic components, and rubber processing industries also may contain trichloroethylene.

From 1987 to 1993, according to the Toxics Release Inventory, trichloroethylene releases to water and land totalled over 291,000 lbs. These releases were primarily from steel pipe and tube manufacturing industries. The largest releases occurred in Pennsylvania and Illinois. The largest direct releases to water occurred in West Virginia.

What happens to Trichloroethylene when it is released to the environment?

Trichloroethylene released to soil will either evaporate or leach into ground water. If released to water, it will also quickly evaporate. It has only a moderate potential to accumulate in aquatic life.

How will Trichloroethylene be Detected in and Removed from My Drinking Water?

The regulation for trichloroethylene became effective in 1989. Between 1993 and 1995, EPA required your water supplier to collect water samples every 3 months for one year and analyze them to find out if trichloroethylene is present above 0.5 ppb. If it is present above this level, the system must continue to monitor this contaminant.

If contaminant levels are found to be consistently above the MCL, your water supplier must take steps to reduce the amount of trichloroethylene so that it is consistently below that level. The following treatment methods have been approved by EPA for removing trichloroethylene: Granular activated charcoal in combination with Packed Tower Aeration.

How will I know if Trichloroethylene is in my drinking water?

If the levels of trichloroethylene exceed the MCL, 5 ppb, the system must notify the public via newspapers, radio, TV and other means. Additional actions, such as providing alternative drinking water supplies, may be required to prevent serious risks to public health.

Drinking Water Standards:

	Mclg:  zero
	Mcl:   5 ppb

	Trichloroethylene Releases to Water and Land, 
	1987 to 1993 (in pounds):
	                              Water          Land
	TOTALS (in pounds)            100,293        191,088

	Top Six States*

	PA                            0              33,450  
	IL                            0              30,711  
	GA                            3,742          17,532  
	TX                            0              21,000  
	MA                            0              19,920  
	WV                            12,822         0  

	Major Industries

	Steel pipe, tubes             31             39,288
	Misc. Indust. Organics        27,708         0
	Car parts, access.            4,405          19,920
	Plating, polishing            3,342          20,100
	Wool fabric mills             3,942          18,081

	* State totals only include facilities with releases greater
	than 10,000 lbs.